SIP provider on a Siemens HiPath 3800 PBX

Setting up a SIP provider on a Siemens HiPath 3800 PBX

Pre requirements:

• HiPath 3000 V6.0 / V7.0 / V8.0 PBX
• HXG 1500 card
• Broadband Internet Access
• A sip provider account (sipgate, qsc…)
• HiPath 3000 Manager E
• About 10 minutes time to set it up

You can view the tutorial online or download the PDF file here

First logon to the HXG 1500 and authenticate.

Now select the Explorers tab, hit Voice Gateway and Internet Telephony Service Provider.

Rightclick your Provider and hit Edit Internet Telephony Service Provider.

Tick the Enable Provider check box and select the Provider Identifier (Provider 1) and verify that all those settings are correct.

Now you have to setup your SIP logon, right click your created provider and hit Add Internet Telephony Station.

Enter your account details and press Apply.

Next you have to add an MSN which is the number that is sent out to your provider as caller number and used for inbound calls.

Right click MSN and hit Add MSN. Insert your number the destination that will ring when this number is dialled and press Apply.

On the Manager E, select Lines/Networking and hit IP Trunks. In there create the same amount of B-Channels that you have selected on the HXG card and select the same provider as in the network card and hit Add.

 Browse to least cost routing and activate it and set it to en-bloc sending.

Under Routes rename the Trk Group 14 to your provider name. 

In the configured routing tables setup the route Sipgate (Your provider name) and create a Dial rule with the following settings for the internal destination starting with the dash (-)

That’s it happy testing and phoning ;)